ISO/TR TECHNICAL REPORT 14468 First edition 2010-12-15 Selected illustrations of attribute agreement analysis Illustrations choisies d'une analyse d'accord d'attribut Reference number ISO/TR 14468:2010(E) 1 @ ISO 2010 Tby IHS under lic Not for Resale ISO/TR 14468:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by Iso member bodies. In COPYRIGHTPROTECTEDDOCUMENT @ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @IsO2010-All rightsreserved ed without license from IHS Not for Resale ISO/TR 14468:2010(E) Contents Page Foreword i Introduction 1 Scope 2 Normative references 3 Terms and definitions 4 Symbolsandabbreviatedterms.. 3 5 Generic description of attribute agreement analysis . 5.1 Overview of the structure of attribute agreement analysis. 5.2 Overall objectives of attribute agreement analysis .. 5.3 Measurementprocessdescription.... 5.4 Agreement analysis methodology. 5.5 Sampling plan for attribute agreement analysis 5.6 Data analysis... 5.7 Conclusions and suggestions 6 Description of Annexes A to E.. Annex A (informative) Liquid crystal display manufacture . .8 Annex B (informative) Technical support centre triage of issues .. Annex C (informative) Tasting differences in water. Annex D (informative) Thermistor defects . Annex E (informative) Assessment of level of disability following a stroke Bibliography..... Copyright Inteatinal organizainfr standardizaliri ghts reserved ii THS und nse from IHS Not for Resale
ISO TR 14468 2010 Selected illustrations of attribute agreement analysis