ISO INTERNATIONAL STANDARD 5267-2 Second edition 2001-09-15 Pulps Determination of drainability - Part 2: "Canadian Standard" freeness method Pates-Détermination de I'égouttabilite- Partie 2: Méthode de mesure de I'indice d'egouttage Canadian Standard Reference number ISO 5267-2:2001(E) Tso @ ISO 2001 ISO 5267-2:2001(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ ISO 2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland @ ISO 2001 - All rights reserved ISO 5267-2:2001(E) Contents Page Foreword. Introduction 1 Scope 2 Normative references 3 Term and definition . 4 Principle.. 5 Apparatus 6 Preparation of sample. Procedure 8 Expression of results.. 9 Test report. Annex A (normative) The "Canadian Standard" freeness tester Annex B (normative) Maintenance of the "Canadian Standard" freeness tester.. 10 Annex C (normative) Calibration Service .. Annex D (informative) Table of freeness corrections to 0,3o % stock concentration.. Annex E (informative) Table of freeness corrections to 20 °C Bibliography ili