ISO INTERNATIONAL STANDARD 4254-11 First edition 2010-12-15 Agricultural machinery Safety - Part 11: Pick-up balers Matériel agricole Sécurite Partie 11: Ramasseuses-presses Reference number ISO 4254-11:2010(E) @ISO 2010 ISO 4254-11:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In COPYRiGHTPROTECTEDDOCUMENT ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or ISo's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @IsO2010-All rightsreserved ISO 4254-11:2010(E) Contents Page Foreword Introductior 1 Scope. 2 Normative references. 3 Terms and definitions. 4 List of significant hazards . 5 Safety requirements and/or protective measures 5.1 General..... 5.2 Requirements for all types of balers . 5.3 Requirementsforrectangularbalers 5.4 Requirements for round balers.... 12 6 Verification of the safety requirements and/or protective measures L Information for use 7.1 Operator's manual.. .13 7.2 Marking 14 Bibliography.. 15 'ghts reserved ili