ISO INTERNATIONAL STANDARD 29262 First edition 2011-03-01 Production equipment for microsystems Interface between end effector and handling system Equipement de production pour systemes microtechniques Interface entreoutiletdispositifdemanipulation Reference number ISO 29262:2011(E) @ISO2011 ISO 29262:2011(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is atrademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, ISo's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. +4122 749 0111 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2011 - All riahts reserved ISO 29262:2011(E) Contents Page Foreword. Introductio 1 2 Normativereferences 3 Terms and definitions ... 4 General 5 Interface definitions 5.1 Coordinate system .. 5.2 Layer 1 - Mechanical interface.. 5.3 Layer 2- Service interface 5.4 Layer3- Bus interface part. 5.5 Tolerances.. 14 5.6 Load-bearing capacities 14 5.7 Designation .... Annex A (normative) Tests procedure for fixation interface, PR 16 Bibliography ""ahts reserved ili
ISO 29262 2011 Production equipment for microsystems — Interface between end effector and handling system