EN ISO 286-2 EUROPEANSTANDARD NORME EUROPEENNE EUROPAISCHE NORM June 2010 ICS17.040.10 Supersedes EN 20286-2:1993 English Version Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (lisO 286 2:2010) Spécificationgeometriquedesproduits(GPS)-Systeme GeometrischeProduktspezifikation (GPS)-ISO de codification IsO pour les tolerances sur ies talles Toleranzsystem fur LangenmaBe - Teil 2: Tabellen der lineaires - Partie 2: Tableaux des classes de tolerance Grundtoleranzgrade und GrenzabmaBe fur Bohrungen und normaliseesetdesécartslimitesdesalesagesetdes Wellen (ISO286-2:2010) arbres (ISO 286-2:2010) ThisEuropeanStandardwasapprovedbyCENon15May2010 CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Management Centre or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the officialversions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. cen EUROPEANCOMMITTEEFOR STANDARDIZATION COMITEEUROPEENDENORMALISATION EUROPAISCHESKOMITEEFURNORMUNG Management Centre: Avenue Marnix 17, B-1000 Brussels @2010CEN All rights of exploitation in any form and by any means reserved Ref.No.EN ISO 286-2:2010: E worldwidefor CEN national Members. BSENISO286-2:2010 ENISO286-2:2010 (E) Foreword and geometrical product specifications and verification" in collaboration with Technical Committee CEN/TC 29o “Dimensional and geometrical product specification and verification" the secretariat of which is heldbyAFNOR. atthelatestbyDecember2010. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent This document supersedes EN 20286-2:1993. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Lithuania,Luxembourg,Malta,Netherlands,Norway,Poland,Portugal,Romania,Slovakia,Slovenia,Spain Sweden, Switzerland and the United Kingdom. Endorsement notice BS EN ISO 286-2:2010 ISO 286-2:2010(E) Contents Page Foreword .iv Introduction 1 Scope, 2 Normativereferences. 3 Standard tolerances 4 Limitdeviations forholes.. 5 Limit deviations for shafts.. 6 PresentationofTables2to32. Annex A (informative) Graphical review of tolerance intervals for holes and shafts Annex B (informative) Relationship to the GPS matrix model. Bibliography .52 @ Is0 2010 - All rights reserved ili