ISO INTERNATIONAL STANDARD 27955 First edition 2010-08-01 Road vehicles Securing of cargo in passenger cars, station wagons and multi-purpose vehicles Requirements and test methods Vehicules routiers - Arrimage des charges a bord des voitures particulieres, des breaks et des vehicules a usages multiples - Exigences et méthodes d'essai Reference number ISO 27955:2010(E) @ ISO 2010 ISO 27955:2010(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISO's member body in the country of the requester ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ ISO 2010 - All rights reserved Provided by IHS se from IHS Not for Resale ISO 27955:2010(E) Contents Page Foreword Introduction 1 Scope 2 Normative references 3 Terms and definitions 4 Requirements. 4.1 General 4.2 Backrests/seats 4.3 Partitioning system 4.4 Lashing points . 4.5 Loading instructions ... 5 Testing 5.1 Equipment 5.2 Test preparation 5.2.1 General. 5.2.2 Test block positioning for seat testing .... 5.2.3 Test block positioning for testing of the partitioning system . 5.3 Dynamic testing of backrests and partitioning systems.... 14 5.4 Testing of lashing points. 4 5.4.1 Test procedure... 5.4.2 Calculation 14 Bibliography.. Iso 2010-All rights reserved ii se from IHS