ISO INTERNATIONAL STANDARD 23519 First edition 2010-06-01 Sintered metal materials, excluding hardmetals Measurement of surface roughness Materiaux metalliques frittes, a I'exclusion des métaux-durs - Mesurage de la rugosité de surface Reference number ISO 23519:2010(E) @ ISO 2010 by IHS under lic itted without license from IHS Not for Resale ISO23519:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHT PROTECTED DOCUMENT ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISsO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Copyrgh Interatinal Oorganization for Standardization IsO2010-All rights reserved I without license from IHS Not for Resale ISO 23519:2010(E) Contents Page Foreword .iv 1 Scope 2 Normative references 3 Terms and definitions 4 Symbols and units.. 5 Principle.. .2 6 Procedure. 7 Expression of results Bibliography.... CopyrghtInternational OrganizaionSadardizaoghtsreserved ii d by IHS under se with I: ed without license from IHS Not for Resale
ISO 23519 2010 Sintered metal materials, excluding hardmetals — Measurement of surface roughness