FINAL INTERNATIONAL ISO/FDIS DRAFT STANDARD 20567-3 IS0/TC35/SC9 Paints and varnishes Determination Secretariat: BSI of stone-chip resistance of coatings Voting begins on: 2012-09-27 Part 3: Voting terminates on: Single-impact test with a free-flying 2012-11-27 impact body Peintures et vernis Détermination de la résistance des revetements aux impactsde cailloux- Partie 3: Essai de choc simple par corps percutant en vol libre Please see the administrative notes on page ii RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEYAREAWAREANDTO PROVIDE SUPPORTING DOCUMENTATION INADDITIONTOTHEIR EVALUATIONAS Reference number BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO- ISO/FDIS 20567-3:2012(E) LOGICAL,COMMERCIAL AND USER PURPOSES, DRAFT INTERNATIONAL STANDARDS MAY ON LSO OCCASIONHAVETOBECONSIDEREDINTHE LIGHT OFTHEIR POTENTIALTO BECOME STAN- DARDS TO WHICH REFERENCE MAY BE MADE IN Copyright International Organization for Standardization NS @ISO2012 HS unde from IHS Not for Resale IS0/FDIS20567-3:2012(E) Copyright notice This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted under the applicable laws of the user's country, neither this IsO draft nor any extract from it may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, photocopying, recording or otherwise, without prior written permission being secured. Requests for permission to reproduce should be addressed to either IsO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 0111 Fax+41227490947 E-mail copyright@iso.org Web www.iso.org Reproduction may be subject to royalty payments or a licensing agreement. Violators may be prosecuted. @ IS0 2012 - All rights reserved withoutlicense from IHS Not for Resale IS0/FDIS 20567-3:2012(E) ISO/CEN PARALLEL PROCESSING This final draft has been developed within the International Organization for Standardization (Iso), and pro- cessed under the Iso-lead mode of collaboration as defined in the Vienna Agreement. The final draft was established on the basis of comments received during a parallel enquiry on the draft. This final draft is hereby submitted to the ISO member bodies and to the CEN member bodies for a parallel two-month approval vote in ISO and formal vote in CEN. Positive votes shall not be accompanied by comments. Negative votes shall be accompanied by the relevant technical reasons. iii No reproduction or Not for Resale