ISO INTERNATIONAL STANDARD 1927-1 First edition 2012-08-01 Monolithic (unshaped) refractory products - Part 1: Introduction and classification Produits réfractaires (nonfaconnés) monolithiques- Partie 1: Introduction et classification Reference number ISO 1927-1:2012(E) ISO @ISO2012 No reproduction or networking permitted without license from IHS Not for Resale ISO 1927-1:2012(E) COPYRiGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO 2012 - All rights reserved or networking permited withoutlicense from IHS Not for Resale ISO 1927-1:2012(E) Contents Page Foreword ..iv Introduction 1 Scope 2 Normative references 3 Terms and definitions. 4 Product types and methods of placement, 4.1 Refractory castables... 4.2 Refractory gunning materials 4.3 Refractory ramming materials 4.4 Refractory jointing materials. 4.5 Other monolithic (unshaped) refractory products 5 Type of chemical composition. 5.1 Alumina-silica products 5.2 Basic products. 5.3 Special products. 5.4 Carbon-containing products, 6 Classification.. 6.1 General 6.2 Main raw material .... 6.3 Classification temperature.. 7 Designation of a monolithic (unshaped) refractory material. Bibliography ili lout license from IHS Not for Resale