ISO INTERNATIONAL STANDARD 16063-12 First edition 2002-04-01 Methods for the calibration of vibration and shock transducers - Part 12: Primary vibration calibration by the reciprocity method Methodes pour I'etalonnage des transducteurs de vibrations et de chocs Partie 12: Etalonnage primaire de vibrations par méthode réciproque Reference number A ISO 16063-12:2002(E) ISO @ ISO 2002 HS under I without license from IHS Not for Resale ISO 16063-12:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland @ISO2002-All rights reserved py IHS unde ermittedwithoutlicense from IHS Not for Resale ISO 16063-12:2002(E) Contents Page Foreword. iv 1 Scope 2 Normative references. 3 Uncertaintyofmeasurement.. 4 Symbols. 5 Requirements for apparatus. 6 Ambient conditions 7 Preferred amplitudes and frequencies. 8 Procedure.. 9 Computation of sensitivity.. .6 Annex A (normative) Calculation of uncertainty... 10 Annex B (informative) Application of the theory of reciprocity to the calibration of electromechanical transducers.... 14 Bibliography. 20 ili se from IHS Not for Resale