FINAL INTERNATIONAL ISO/FDIS DRAFT STANDARD 12013-1 ISO/TC35/SC9 PaintsandvarnishesDetermination Secretariat: BSI ofcuringcharacteristicsusingafree Voting begins on: 2012-07-26 damped oscillation method Votingterminates on: Part 1: 2012-09-26 Starting temperature of the curing reaction Peintures et vernis -Détermination des caracteristiques de polymerisation par une methode utilisant un pendule amorti Partie1:Temperature dedebut de réaction depolymerisation RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPOR- TING DOCUMENTATION INADDITION TOTHEIR EVALUATION AS Reference number LOGICAL, COMMERCIAL AND USER PURPOSES ISO/FDIS 12013-1:2012(E) DRAFT INTERNATIONAL STANDARDS MAY ON ISO OCCASION HAVE TO BE CONSIDERED IN THE LIGHTOFTHEIRPOTENTIALTOBECOMESTAN DARDS TO WHICH REFERENCE MAY-BE·MADEIN Copyright IntermationalOrganizationforStandardizationNS @ISO2012 ense from IHS Not for Resale ISO/FDIS12013-1:2012(E) Copyright notice This IsO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted under the applicablelaws oftheuser's country,neitherthis IsO draft nor any extractfrom itmay be reproduced, or otherwise, without prior written permission being secured. Requests for permission to reproduce should be addressed to either IsO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56·CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +41227490947 E-mail copyright@iso.org Web www.iso.org Reproduction may be subject to royalty payments or a licensing agreement. Violators maybeprosecuted. @ ISO 2012 -All rights reserved No reproduction or etworking permitted without license from IHS Not for Resale ISO/FDIS12013-1:2012(E) Contents Page Foreword ..iv Introduction 1 Scope 2 Normative references 3 Terms and definitions. 4 Principle 2 5 Pendulum-dampingapparatus 2 6 Sampling. 6 7 Test panels 6 7.1 Substrate. 6 7.2 Preparationandcoating 6 7.3 Thickness of coating 8 Procedure 6 Expressionofresults 8 10 Precision 8 10.1 General.. .8 10.2 Repeatability limit.. 8 10.3 Reproducibility limit 8 11 Test report 8 AnnexA(informative)Selectionofpendulumandknifeedge 9 Bibliography ili ense from IHS Not for Resale