ISO INTERNATIONAL STANDARD 11748-1 First edition 2001-06-01 Road vehicles Technical documentation of electrical and electronic systems - Part 1: Content of exchanged documents Vehicules routiers Documentation technique des systemes électriques et électroniques- Partie 1: Contenu des documents échangeés Reference number ISO 11748-1:2001(E) Tso @ ISO 2001 Copyright International Organization for Standardization No reproduction or networking permited without license from IHS Not for Resale ISO 11748-1:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2001 tronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's mem- ber body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 4122 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland pyhatoganizatSandadizatio @ ISO 2001 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 11748-1:2001(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been established has liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of IsO 11748 may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 11748-1 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC 3, Electrical and electronic equipment. ISO 11748 consists of the following parts, under the general title Road vehicles - Technical documentation of electrical and electronic systems: Part 1: Content of exchanged documents Part 2:Documentation agreement - Part 3:Application example CopyrightInternational Organization for Standardization served ii Not for Resale