ISO INTERNATIONAL STANDARD 11485-1 First edition 2011-12-15 Glass in building Curved glass - Part 1: Terminology and definitions Verre dans la construction - Verre bombe - Partie 1: Terminologie et définitions Reference number ISO 11485-1:2011(E) LSO @ISO2011 IHS under lic itted without license from IHS Not for Resale ISO 11485-1:2011(E) COPYRIGHTPROTECTEDDOCUMENT ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO 2011 -All rights reserved No reproductic etworking permitted without license from IHS Not for Resale ISO 11485-1:2011(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental,inliaisonwithIsO,alsotakepartinthework.IsOcollaboratescloselywiththeInternational Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 11485-1 was prepared by Technical Committee ISO/TC 160, Glass in building, Subcommittee SC 1, Product considerations. IsO 11485 consists of the following parts, under the general title Glass in building - Curved glass: Part 1:Terminologyand definitions Part2:Qualityrequirements - Part 3: Requirements for tempered and laminated curved safety glass1) 1)Under preparation. ili Not for Resale