ISO INTERNATIONAL STANDARD 11096 Second edition 2011-09-15 Road vehicles Pedestrian protection - Impact test method for pedestrian thigh, leg and knee Vehicules routiers- Protection des piétons- Methode d'essai de choc pour la cuisse, la jambe inferieure et le genou des pietons Reference number ISO 11096:2011(E) @ ISO 2011 IHSunder Not for Resale ISO 11096:2011(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or isO's memberbody in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO 2011 - All rights reserved itted without license from IHS Not for Resale ISO 11096:2011(E) Contents Page Foreword Introduction 1 Scope 2 Normative references 3 Terms and definitions, 3.1 Legform impactor 3.2 Vehicle.. 4 Test equipment.. 4.1 Impact test site ... 4.2 Legform impactor. 4.3 Propulsion system . 4.4 Applicable vehicles ... 5 Requirements 5.1 Legform impactor 5.2 Propulsion of legform impactor.. 5.3 Legformimpactorsetting 5.4 Testtemperature 6 Preparation of test vehicle 7 Test conditions 7.1 Atmosphericconditions 7.2 Angle of impact.. 7.3 Impactpoint. 7.4 Impact velocity.. 8 Measurement requirements for legform impactor.. 8.1 Data acquisition... 8.2 Legform impactor data... 8.3 Test specimen............. AnnexA(normative)Biofidelicperformancecharacteristics. Annex B (normative) Legform impactor certification .. Annex C (informative) Data sheet.. 14 Annex D (informative) Comments on the test procedure ... Bibliography ii from IHS Not for Resa