ISO INTERNATIONAL STANDARD 1102 Third edition 2001-10-15 Commercial road vehicles 50 mm drawbar eye Interchangeability Vehicules routiers utilitaires — Anneaux de remorquage de 50 mm - Interchangeabilite Reference number ISO 1102:2001(E) ISO @ ISO 2001 IHSunder 44001, User=kxy, qz ISO 1102:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic inthe country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland @ ISO 2001 - All rights reserved itted without license from IHS ISO 1102:2001(E) Foreword ISO(theInternationalOrganizationforStandardization)isaworldwidefederationofnationalstandardsbodies(iS member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been established has liaisonwithIsO,alsotakepartinthework.IsOcollaboratescloselywiththeInternationalElectrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISsO 1102 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC15 Interchangeabilityofcomponents of commercialvehicles and buses. This third edition cancels and replaces the second edition (isO 1102:1986), which has been technically revised nationai Organizatinfor standardizalionserved ii