ISO INTERNATIONAL STANDARD 10893-3 First edition 2011-04-01 Non-destructive testing of steel tubes - Part 3: Automated full peripheral flux leakage testing of seamless and welded (except submerged arc-welded) ferromagnetic steel tubes for the detection of longitudinal and/or transverse imperfections Essais non destructifs des tubes en acier Partie 3: Controle automatisé par flux de fuite sur toute la circonférence des tubes en acier ferromagnétique sans soudure et soudés (sauf a I'arc immerge sous flux en poudre) pour la detection des imperfections longitudinales et/ou transversales Reference number ISO 10893-3:2011(E) @ ISO 2011 ISO 10893-3:2011(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT @ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISo's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail
[email protected] Web www.iso.org Published in Switzerland @ Iso 2011 - All rights reserved I without license from IHS Not for Resale ISO10893-3:2011(E) Contents Page Foreword iv 1 Scope 2 Normative references 3 Terms and definitions .. 4 General requirements . 5 Test method. 6 Reference tube. 6.1 General.. 6.2 Reference notches 7 Equipment calibration and checking. 8 Acceptance 9 Test report. Annex A (normative) Limitations of magnetic flux leakage test method.. Copyright International Organization for Standardizalon ghts reserved ii from IHS Not for Resale
ISO 10893-3 2011 Non-destructive testing of steel tubes — Part 3 Automated full peripheral flux leakage testing of seamless and welded (except submerged arc-welded) ferromagnetic steel tubes for the
文档预览
中文文档
17 页
50 下载
1000 浏览
0 评论
309 收藏
3.0分
温馨提示:本文档共17页,可预览 3 页,如浏览全部内容或当前文档出现乱码,可开通会员下载原始文档
本文档由 人生无常 于 2024-08-31 09:29:20上传分享