ISO INTERNATIONAL STANDARD 10510 Second edition 2011-04-01 Tapping screw and washer assemblies with plain washers Visatolearondelleplateimperdable Reference number ISO10510:2011(E) @ISO2011 for Standardizatio No reproduction or networking permitted without license from IHS Not for Resale ISO10510:2011(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or isO's memberbody in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland rganization for Standardization @ ISO 2011 -All rights reserved No reproduction or networking permited without license from IHs Not for Resale ISO 10510:2011(E) Foreword IsO (the International Organization for Standardization)is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through isO non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission(IEC)onall mattersofelectrotechnical standardization. International Standardsaredrafted inaccordancewith the rulesgiven in theISO/IEC Directives,Part 2 International Standardrequiresapproval byatleast75%ofthememberbodiescastingavote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 10510 was prepared by Technical Committee ISO/TC 2, Fasteners, Subcommittee SC 10, Product standardsforfasteners. This second edition cancels and replaces the first edition (IsO 10510:1999), of which it constitutes a minor revision. lization'ghtsreserved ili Not for Resale